Citizen C460 Bedienungsanleitung PDF herunterladen

Citizen Movement/Cal. C460

Abbreviated Instructions

FEATURES

30 Cities/ 22 Time Zones

Analog and Digital Display

Calendar

2 Alarms

24 Hour, 1/100 Second Chronograph

99 Minute Countdown Timer

Dual Time

Electro-luminescence

BENEFITS

Worldwide Time

Time at a Glance

Perpetual for 100 years

Use Alarm 2 for Snooze

Split-Second Precise Timing

Sounds Signal When Time is Up

See Two Time Zones

Time Visible at Night

Click Here for Full Setting Instructions (176k pdf)

NOTE: After a battery change or an abnormal

display or function is noticed, an ALL RESET

is required. Be sure to set the time and date

after performing the ALL RESET.

ALL RESET PROCEDURE

Press and release the upper left button (M) to

move mode indicator to TME (time) mode.

Pull the crown out to setting position.

Press the upper left (M), lower left(B) and lower

right(A) buttons down simultaneously for 3

seconds, then release them. All digital segments

in the displays will be highlighted (black).

Press crown in. At this point, a beep is heard

indicating that ALL RESET is complete. Set

correct time and calendar and other modes as

needed.

TO SET THE ANALOG TIME

Pull crown out to hand setting position and turn

crown.

TO SWITCH DIGITAL MODES

Modes can be changed in the following

sequence: TME (time), CAL (calendar), AL-1 and

AL-2 (alarms), CHR (chronograph), TMR (timer),

SET (zone setting) by pushing and releasing the

Mode (M) button.

TO SET THE DIGITAL TIME

Press the lower left button (B) to move the time

zone city code into digital display II.

If TME is not showing in digital mode display,

press the upper left button (M) button to select

TME.

Press the lower left button (B) in and hold for 3

seconds to switch to digital time setting mode.

S.T. (summer time) used for daylight saving time

and "ON" or "OF" will begin flashing.

Press lower right button (A) to select S.T. "ON"

or "OF" (off).

Press and release lower left button (B).

Seconds figures will flash. Use lower right

button (A) to reset seconds.

*Press and release the lower left button (B).

Minutes will flash. Press the lower right button

(A) to adjust minutes. Hold the lower right button

(A) continuously for rapid change.

Press and release the lower left button (B).

Hours will flash.

Press the lower right button (A) to set hours

according to a.m. or p.m.

Press the lower left button (B). 12H will flash.

Press the lower right button (A) to select 24H

(military time) if desired.

Press the lower left button (B) or the upper

left button ( M) to return to normal time display.

TO SET THE CALENDAR

Press and release the upper left button (M)

to move mode indicator to CAL (calendar).

Digital display I shows Month and Date.

Digital display II shows City Code.

Hold the lower left button (B) in for three

seconds and then release. Month number

starts flashing. Press the lower right button (A)

to advance month number.

Press and release lower left button (B). Date

starts flashing. Press the lower right button (A)

to advance date.

Press and release the lower left button (B).

Digital display I shows the year and year

numbers will be flashing. Press the lower right

button (A) to advance year.

After the lower left button (B) or upper left

button ( M) is pressed, digital display l shows

month (numeric) and date.

TO SET ALARMS (ALM 1 & 2 )

Pressing the upper left button (M), move the

mode indicator to ALM 1 (or ALM 2).

Press and hold the lower left button (B) for 3

seconds then release it. The hours in digital

display I will flash.

Press the lower right button (A) to advance

hours.

Press and release the lower left button (B).

Minutes in digital display I will flash. Press the

lower right button (A) to set minutes.

Setting alarm time sets alarm to on.

Press the lower left button (B) to finalize

setting.

To switch alarm off or on while in alarm

mode, press the lower right button (A). While

in alarm mode, digital display II shows city

code.

TO USE THE CHRONOGRAPH

Press upper left button (M) to move to

CHR mode. The chronograph can measure

up to 23 hour, 59 minutes, 59 and 99/100

seconds.

Press the lower right button (A) to start or

stop chronograph. Digital display I shows

minutes, seconds and 1/100 seconds.

Digital display Il shows measured time

hours.

If the lower left button (B) is pressed while

chronograph is running, a split time is

displayed for 10 seconds as chronograph

continues counting elapsed time internally.

If the lower left button (B) is pressed when

counting is stopped, chronograph is reset to

zero.

TO USE THE TIMER

Press the upper left button (M) to move to

TMR (Timer mode). Timer can be set to

countdown from 99 minutes down to 1

minute in 1-minute intervals. Digital display

ll shows Timer set time in minutes and

digital display I shows Timer minutes and

seconds remaining.

Press lower left button (B) to set Timer

minutes.

Press lower right button (A) to start or stop

Timer countdown.

Pressing lower left button (B) after Timer

is stopped resets it to original Timer set

time.

If the lower left button (B) is pressed while

Timer is running, the time is reset to the

original Timer set time and restarts the

countdown automatically. When Timer

counts down to zero, the time up signal

sounds for 5 seconds and the display

returns to the Timer set time and stops.

For additional features and instructions,

please refer to the full instruction manual

or our web site at ww.citizenwatch.com.

Inhaltsverzeichnis

Seite 1 - Abbreviated Instructions

Citizen Movement/Cal. C460 Abbreviated Instructions FEATURES 30 Cities/ 22 Time Zones Analog and Digital Display Calendar 2 Alarms 24 Hour, 1/10

Kommentare zu diesen Handbüchern

Keine Kommentare

Citizen C460 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Wecker Citizen C460 herunter. Citizen Movement/Cal Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern